CRITICAL • 1G = Motor 1, 2G = Motor 2

Lippert Schwintek Slide-Out: 4 Red Blinks — Open Circuit (Secondary Check)

Continuous open-circuit state detected on the indicated motor channel.

← Live Decoder
GREEN (Motor)
RED (4x)
− 4 Red Blinks + Match the flashing Red LED rhythm on your V-Sync controller.
Field Safety Warning: Support the slide box evenly if removing an upper motor to avoid binding the opposite track.

Checkable Field Troubleshooting Steps

Most Probable Root Causes

  • Corroded pin in the 4-pin Molex plug
  • Broken wire at the factory butt-splice inside the wall
  • Failed internal MOSFET relay on the controller board
Emergency Electronic Override (6-Press + 7th Hold)
  1. Locate the Schwintek V-Sync controller (usually inside a storage bay or wardrobe near the slide).
  2. Press the tiny recessed Mode Button cleanly 6 times, then press and HOLD on the 7th press for ~5 seconds until Red & Green LEDs flash rapidly.
  3. Release the button. Both motors are now in manual override—immediately use the interior wall switch to retract the slide evenly for travel.
  4. Manual Mechanical Override: Unplug Motor 1 and Motor 2 from the controller to release electronic braking, then push the room straight in with two helpers.
Deep-Dive Technical Guide
Schwintek Slide-Out Master Guide

How the Schwintek dual-motor V-Sync controller counts Hall-effect pulses, why 8 Red Blinks happens at campgrounds, how to test motors with a multimeter, and safe override steps.

Read Complete Field Guide →

OEM Replacement Parts & Cross-References

Lippert OEM: 247768
Schwintek Slide-Out Wire Harness (Motor to Controller)
Cross-Ref: 229934

Fixes intermittent 2R/8R encoder feedback faults caused by pinched harness.

Lippert OEM: 13398-DO
Schwintek V-Sync II Dual Motor Slide Controller
Cross-Ref: 13398-C2 / 211852

Upgraded green-board replacement for older 13398-C2 modules.

Disclosure: As an Amazon Associate and eBay Partner, CodeMyRV earns from qualifying purchases at no additional cost to you. See our Affiliate Disclosure.

Frequently Asked Questions About Schwintek Slide 4R

What does Schwintek Slide fault 4R mean?

Continuous open-circuit state detected on the indicated motor channel.

What are the most common causes of Schwintek Slide 4R?

Corroded pin in the 4-pin Molex plug; Broken wire at the factory butt-splice inside the wall; Failed internal MOSFET relay on the controller board.

What safety precautions apply before troubleshooting 4R?

Support the slide box evenly if removing an upper motor to avoid binding the opposite track. Always disconnect 120V shore power and shut off LP gas supply valves before probing live electrical or gas components.

Other Lippert Schwintek Slide-Out Fault Codes