CRITICAL • 1G = Motor 1, 2G = Motor 2

Lippert Schwintek Slide-Out: 8 Red Blinks — Hall Effect Signal Lost / Out of Sync

The #1 most common Schwintek fault: Motor 1 and Motor 2 drifted out of sync or lost Hall pulses mid-travel.

← Live Decoder
GREEN (Motor)
RED (8x)
− 8 Red Blinks + Match the flashing Red LED rhythm on your V-Sync controller.
Field Safety Warning: Always hold the wall switch for 2–3 seconds AFTER the slide stops moving—releasing early is the top cause of 8R drift.

Checkable Field Troubleshooting Steps

Most Probable Root Causes

  • One side binding slightly faster than the other (cocked room)
  • Weak/aging 236575 motor slipping counts
  • Releasing the wall switch prematurely before full stop
Emergency Electronic Override (6-Press + 7th Hold)
  1. Locate the Schwintek V-Sync controller (usually inside a storage bay or wardrobe near the slide).
  2. Press the tiny recessed Mode Button cleanly 6 times, then press and HOLD on the 7th press for ~5 seconds until Red & Green LEDs flash rapidly.
  3. Release the button. Both motors are now in manual override—immediately use the interior wall switch to retract the slide evenly for travel.
  4. Manual Mechanical Override: Unplug Motor 1 and Motor 2 from the controller to release electronic braking, then push the room straight in with two helpers.
Deep-Dive Technical Guide
Schwintek Slide-Out Master Guide

How the Schwintek dual-motor V-Sync controller counts Hall-effect pulses, why 8 Red Blinks happens at campgrounds, how to test motors with a multimeter, and safe override steps.

Read Complete Field Guide →

OEM Replacement Parts & Cross-References

Lippert OEM: 236575
Schwintek In-Wall Slide-Out Motor (300:1 High Torque)
Cross-Ref: IG-42 300:1

10mm shaft, 12V DC with 10-pole Hall-effect encoder. Most common 8R/9R replacement.

Lippert OEM: 13398-DO
Schwintek V-Sync II Dual Motor Slide Controller
Cross-Ref: 13398-C2 / 211852

Upgraded green-board replacement for older 13398-C2 modules.

Disclosure: As an Amazon Associate and eBay Partner, CodeMyRV earns from qualifying purchases at no additional cost to you. See our Affiliate Disclosure.

Frequently Asked Questions About Schwintek Slide 8R

What does Schwintek Slide fault 8R mean?

The #1 most common Schwintek fault: Motor 1 and Motor 2 drifted out of sync or lost Hall pulses mid-travel.

What are the most common causes of Schwintek Slide 8R?

One side binding slightly faster than the other (cocked room); Weak/aging 236575 motor slipping counts; Releasing the wall switch prematurely before full stop.

What safety precautions apply before troubleshooting 8R?

Always hold the wall switch for 2–3 seconds AFTER the slide stops moving—releasing early is the top cause of 8R drift. Always disconnect 120V shore power and shut off LP gas supply valves before probing live electrical or gas components.

Other Lippert Schwintek Slide-Out Fault Codes